[ stefy @ 17.01.2002. 18:58 ] @
| Kao prvo procitao sam CD-Writing-HowTo. E sad, dmesg: =========================================== DC395x: Used settings: AdapterID=07, Speed=0(20.0MHz), DevMode=0x57 DC395x: AdaptMode=0x0f, Tags=4(16), DelayReset=1s DC395 : Connectors: int50 Termination: Auto Low High DC395: Performing initial SCSI bus reset DC395x (TRM-S1040): 1 adapters found scsi0 : Tekram DC395U/UW/F DC315/U V1.35, 2001-12-06 Vendor: TEAC Model: CD-ROM CD-532S Rev: 1.0A Type: CD-ROM ANSI SCSI revision: 02 Vendor: TEAC Model: CD-R58S Rev: 1.0J Type: CD-ROM ANSI SCSI revision: 02 Attached scsi CD-ROM sr0 at scsi0, channel 0, id 3, lun 0 Attached scsi CD-ROM sr1 at scsi0, channel 0, id 5, lun 0 DC395x: Target 03: Sync: 48ns Offset 15 (20.8 MB/s) sr0: scsi3-mmc drive: 372x/372x caddy Uniform CD-ROM driver Revision: 3.12 DC395x: Target 05: Sync: 100ns Offset 15 (10.0 MB/s) sr1: scsi3-mmc drive: 24x/24x writer cd/rw xa/form2 cdda tray ====================================================== Mogu da mountujem da citam CD-e. cdrecord: ====================================================== [root@tijuan stefy]# cdrecord -scanbus Cdrecord 1.9 (i686-pc-linux-gnu) Copyright (C) 1995-2000 Jörg Schilling cdrecord: No such file or directory. Cannot open SCSI driver. cdrecord: For possible targets try 'cdrecord -scanbus'. Make sure you are root. ====================================================== Po dokumentu http://www.guug.de:8080/cgi-bin/winni/lsc-orig.pl podrzan je pisac. Gde je problem? |