Ako je to "bcd" folder onda moras cd c:\bcd

@mmwc
Uradio sasm tako,pa onda bcd wxppro i dobio:"Renaming bcd.sam into bcd.cfg,The System cannot find the file specified".I to se vrti non stop.
Sta da radim dalje?

Majstore sta ce ti bartPE za radjenje Bootabilnog XP CD-a.!

Ti ako imas sve Fileove iz XP cd-a i integrirao si SP1. Tebi jos samo Fali IMAGE ili ti ga Bootabilna slika.
Mozes ju skinuti ovdje.!
http://unattended.msfn.org/global/files/boot.img

A Progaram za Radjenje s tom sliku .ISO file
http://unattended.msfn.org/global/files/CDIMAGE_GUI.EXE

@xxxrugby,
ne snalazim se bas najbolje sa ovim tvojim uputstvima.

Ovo ce ti radit samo s XP-om to ti je zbog BOOT.IMG koji je za Win XP.!!! Tako da ako zelis neki drugi CD osim XP-a napravit moras nac drugi BOOT.IMG

Using CDIMAGE GUI

CDIMAGE GUI is just a frontend for the original CDIMAGE commandline tool. The GUI includes it's own CDIMAGE, so you wont need to download it. However if you wish to download just the commandline version, it's listed below.

The CDIMAGE GUI file you'll be downloading is preconfigured with the recommended switches, so all you'll have to change is the directories, volume label, and boot sector path

Download:




Making the Changes

After downloading the GUI EXE, run the file and tell it the directory you wish the CDIMAGE GUI files to be stored. I'll be using C:\CDIMAGE as my directory.

* Start up the file cdimagegui.exe and the very first screen should be

# These two boxes are very important.

* The first box is the source directory for your files. You can either type in the path yourself, or click the disk button and browse to it.
* The second box is the destination ISO file. Just enter the path for you ISO file, and make sure it's not in your source directory.


# Click the Configuration button on the left, then click the Boot tab on the top, and you'll recieve this screen


# Change the path in the box to point to the included boot.img file in the CDIMAGE GUI distrobution.
This bootsector is usable for Windows 2000, Windows XP, and Windows 2003 CDs, however not the 64bit versions.
# Click the Creation tab at the top, and recieve this box



# The box at the bottom with WXPVOL_EN will be what your CD label will become. Type in anything there you want.
# To finish off this creation, click the Creation on the left, and click the Start Image Creaton button near the bottom right.



The ISO file created here can be used to burn in any CD burning program you like. Just select the "Burn Image" option or "Burn ISO" option in the software and select this ISO file. You will not have to set any boot parameters as they are already included in this ISO file.

<sub>[Ovu poruku je menjao xxxrugby dana 09.12.2005. u 22:32 GMT+1]

[Ovu poruku je menjao xxxrugby dana 09.12.2005. u 22:41 GMT+1]</sub>

@xxxrugby,hvala na uputsvima.
Uspeo sam da napravim bootabilni XP,proverio na praznom disku i sve radi.
Hvala jos jednom.

Da li ovaj postupak vazi i za vistu?