[ nesli @ 12.12.2007. 19:26 ] @
Pregledao sam ostale teme ali nisam naisao na slican problem; zaista se izvinjavam ako pitam glupost ali mi je jako potrebna pomoc.

Imam dva racunara, spojenih direktno preko mreznih kartica, sinovljev i moj.
Na moj racunar je prikacen kablovski internet (maticna ploca na mom pc-u ima dve integrisane mrezne kartice, u jednu je ustekan kab. modem, a u drugu mrezni kabel za II pc) i stampac.
Od 4 particija (3 hdd-a) sherujem, pored interneta i stampaca, jednu particiju i jos neke foldere na drugim.
Morao sam da ubacujem jos jednu particiju, a time su se promenile i slovne oznake diskova.

Mislim da je nakon toga prestala da mi funkcionise mreza i to na neki blesav nacin: ja mogu bez problema da pridjem sinovljevom pc-u, on bez problema ima preko mene konekciju i stampac ali ne moze da pridje ni jednom sherovanom folderu kod mene, uz poruku:

(putanja lokacije na koju hocu da pristupim sa drugog na moj pc)... is not accessibile. You might not have premission to use this network resource. Contact the administrator of this server to find out if you have access premissions.
Not enough server storage is available to process this command.

Naravno, probao sam da poukidam firewall i sl, probao sam da prekinem, pa ponovo dozvolim sherovanje, probao sam da napravim novu workgroup itd (kad neko ne zna, onda proba svasta...) ali ma sta uradio, drugi racunar nema pristup mojim diskovima, samo netu i stampacu, a ja i dalje drugom pc-u pristupam bez problema.

Da li neko ima ideju kako da dozvolim pristup mojim diskovima i da li ima volje da mi pomogne?
Hvala unapred!!!

[Ovu poruku je menjao nesli dana 13.12.2007. u 19:59 GMT+1]
[ nesli @ 15.12.2007. 14:21 ] @
Kerpo mi je nasao resenje, pa cu ga okaciti, cisto, ako neko naidje na isti problem:
Solving this problem requires a Registry edit:

1. Click Start, and then click Run.
2. Type regedit, and then click OK.
3. Navigate to the following registry key:
HKEY_LOCAL_MACHINE\System\CurrentControlSet\Services
\LanmanServer\Parameters
4. In the right pane, double-click the IRPStackSize value.

Important: If the IRPStackSize value does not already exist, you will need to create it:
- In the Parameters folder of the registry, right-click the right pane.
- Point to New, and then click DWord Value.
- Type IRPStackSize.

Important: Type "IRPStackSize" exactly as it is displayed because the value name is case-sensitive.
5. Change the Base to decimal.
6. In the Value Data box, type a value that is larger than the value that is listed.
If you created the IRPStackSize value using the procedure described in step 4, the default value is 15. It is recommended that you increase the value by 3. Therefore, if the previous value was 11, type 14, and then click OK.
7. Close the Registry Editor.
8. Restart the computer.