[ Astral Projection @ 23.02.2008. 16:45 ] @
Pokusao sam da instaliram ovu wlan karticu pomocu ndiswrappera ali dobijem ovo kad pokusam da pokrenem mrezu:
shiva:/home/astral/system/Driver/WinXP# ifup wlan0
SIOCSIFFLAGS: No such file or directory
SIOCSIFFLAGS: No such file or directory
Failed to bring up wlan0.


ndiswrapper mi daje ovaj info:
shiva:/home/astral/system/Driver/WinXP# ndiswrapper -l
bcmwl5 : driver installed
device (14E4:4318) present (alternate driver: ssb)

znaci da je drajver ucitan..

evo i ifconfig i iwconfig ako kome treba:
shiva:/home/astral/system/Driver/WinXP# ifconfig -a
eth0 Link encap:Ethernet HWaddr 00:14:85:5e:1b:eb
inet addr:******** Bcast:********** Mask:255.255.255.128
inet6 addr: fe80::214:85ff:fe5e:1beb/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:4496 errors:0 dropped:0 overruns:0 frame:0
TX packets:2550 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:2531607 (2.4 MiB) TX bytes:450776 (440.2 KiB)
Interrupt:22

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:113 errors:0 dropped:0 overruns:0 frame:0
TX packets:113 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:16516 (16.1 KiB) TX bytes:16516 (16.1 KiB)

sit0 Link encap:IPv6-in-IPv4
NOARP MTU:1480 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)

wlan0 Link encap:Ethernet HWaddr 00:18:f3:6f:d8:57
inet addr:192.168.0.88 Bcast:192.168.0.255 Mask:255.255.255.0
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)

wmaster0 Link encap:UNSPEC HWaddr 00-18-F3-6F-D8-57-65-74-00-00-00-00-00-00-00-00
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)



shiva:/home/astral/system/Driver/WinXP# iwconfig
lo no wireless extensions.

eth0 no wireless extensions.

wmaster0 no wireless extensions.

wlan0 IEEE 802.11g ESSID:"Shiva"
Mode:Managed Channel:0 Access Point: Not-Associated
Tx-Power=0 dBm
Retry min limit:7 RTS thr:off Fragment thr=2346 B
Encryption key:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0

sit0 no wireless extensions.


zna li neko u cemu je problem?
[ lord_celtic @ 23.02.2008. 17:06 ] @
Prvo koji distro imas??
A drugo broadcom je savrseno podrzan na linuxu!!
[ lord_celtic @ 23.02.2008. 17:10 ] @
svuko sam sa repoa drivere kod prijatelja na laptopu i radila je super.
nema potrebe za emuliranjem drivera
[ Astral Projection @ 23.02.2008. 17:19 ] @
koristim debian sid\lenny

e i ja sam pokusao da kompajliram drajvere za ovo, ali mi kaze kao da ne moze da nadje kernel source, a znam da imam i source i headers instalirano..
@lord jesi siguran da si napravio za ovaj chipset, posto citam da ima problema ovaj BCM4318?
[ lord_celtic @ 23.02.2008. 17:41 ] @
bas za taj!!
ovo je opensuse 10.3.
[ Astral Projection @ 23.02.2008. 17:44 ] @
da se mozda ne sjecas odakle si skinuo drajvere?
[ lord_celtic @ 23.02.2008. 17:58 ] @
Kazem ti skinuo sa repoa
[ Astral Projection @ 23.02.2008. 21:17 ] @
nasao sam nove drajvere b43 koji rade za 2.6.24 kernel i valjda sam napravio wireless... e sad mi se javlja drugi problem. na laptopu sam prije neki dan pokusao da instaliram neki usb wlan adapter i nije moglo pa sam batalio.. Uglavnom izgleda da sam nesto poremetio kod sadasnjih drajvera. WLan mi je na lapu radio normalno sa ndis drajverima ali sad odbija da se konektuje na mrezu. iwlist scan wlan0 mi pokazuje mrezu ali kad pokusam preko kwifimanagera da se konektujem na nju nista se ne desava... btw obrisao sam sve drajvere od usb adaptera i lsmod mi ne pokazuje da su ucitani.. sta bi sad ovo moglo biti?