[ pereubu @ 30.09.2008. 16:46 ] @
Imam adresu sa kojom mogu ako instaliram xp na njoj da izadjem na internet. Medjutim kada ta adresa se koristi za suse, ja to ne mogu, evo sta dobijam: barmena:~ # route Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 192.168.0.0 * 255.255.255.0 U 0 0 0 eth1 link-local * 255.255.0.0 U 0 0 0 eth1 loopback * 255.0.0.0 U 0 0 0 lo default 192.168.0.1 0.0.0.0 UG 0 0 0 eth1 barmena:~ # traceroute www.yahoo.com traceroute to www.yahoo.com (87.248.113.14), 30 hops max, 40 byte packets 1 192.168.0.1 (192.168.0.1) 1.200 ms 0.537 ms 0.521 ms 2 192.168.0.1 (192.168.0.1)(H!) 1.602 ms (H!) 1.044 ms (H!) 0.546 ms razmena:~ # Naizgled nema nikakvih problema: barmena:~ # ifconfig eth1 Link encap:Ethernet HWaddr 00:30:48:72:1E:EC inet addr:192.168.0.16 Bcast:192.168.0.255 Mask:255.255.255.0 inet6 addr: fe80::230:48ff:fe72:1eec/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:16064023 errors:0 dropped:0 overruns:0 frame:0 TX packets:1930775 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:1546276250 (1474.6 Mb) TX bytes:2042029136 (1947.4 Mb) lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:1715475 errors:0 dropped:0 overruns:0 frame:0 TX packets:1715475 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:2572919428 (2453.7 Mb) TX bytes:2572919428 (2453.7 Mb) Konfiguracija mi je jednostavna, no ipak ne mogu da prodjem ruter (Cisco od Telekoma) sa Suse konfiguracijom ali mogu kada XP postavim na tu adresu. Verzija suse je 10.2. Server govori sa svima koji su u njegovom subnetu, ali kada dodje na ruter on jednostavno ne moze dalje, iako nije problem u adresi. barmena:~ # ifup status eth1 eth1 device: Intel Corporation 82557/8/9 [Ethernet Pro 100] (rev 10) No configuration found for eth1 barmena:~ # /etc/init.d/network restart Shutting down network interfaces: eth0 device: Intel Corporation 82541GI Gigabit Ethernet Controller No configuration found for eth0 Nevertheless the interface will be shut down. done eth1 device: Intel Corporation 82557/8/9 [Ethernet Pro 100] (rev 10) eth1 configuration: eth-id-00:30:48:72:1e:ec done Shutting down service network . . . . . . . . . . . . . done. Hint: you may set mandatory devices in /etc/sysconfig/network/config Setting up network interfaces: lo lo IP address: 127.0.0.1/8 done eth0 device: Intel Corporation 82541GI Gigabit Ethernet Controller No configuration found for eth0 unused eth1 device: Intel Corporation 82557/8/9 [Ethernet Pro 100] (rev 10) eth1 configuration: eth-id-00:30:48:72:1e:ec eth1 IP address: 192.168.0.16/24 done Setting up service network . . . . . . . . . . . . . . done. |