[ Bellucci @ 31.12.2009. 14:03 ] @
Pozdrav,

Imam Sony DCR-HC27E kameru. Kupio sam Firewire kontroler i povezao ga sa racunarom, racunar ga je prepoznao, medjutim kada povezem svoju kameru ne desava se nista.
Molim za pomoc i koristan savet?


Hvala.
[ sonyman @ 11.01.2010. 12:36 ] @


1.Connect an i.LINK® cable (also known as IEEE-1394) to the i.LINK port on the digital camcorder.
2.Connect the other end of the i.LINK® cable to the computer.
NOTES

The computer i.LINK® ports and capture cards may have either 4-pin or 6-pin connections; Sony® digital camcorders use i.LINK® ports with 4 pins. If your computer only has a 6-pin i.LINK® port, then it will be necessary to use a 4-pin to 6-pin i.LINK® cable.

3.Turn on the digital camcorder by moving the POWER switch to the VTR position.
4.Cue the camcorder to the beginning of the video.
5.Turn on the computer.
6.Start the video capture software on the computer.
7.Begin playing the recorded video in the camcorder.
8.Begin importing the video with the capture software.
[ Bellucci @ 17.02.2010. 13:35 ] @
Sve je to u redu i tako sam i uradio ali nijedan softver je ne prepoznaje...

Kamera ima i a/v izlaz a imam i a/v kabal, da li postoji mogucnost preko njega da prebacim?



_
[ deks007 @ 18.02.2010. 15:02 ] @
Kamera treba da je u edit modu kod prebacivanja . Firewire kartica + kabel i to je to ili kod drugara kome sve funkcionise pa probas da prebacis sa svoje kamere . Pozdrav !