[ fangorn @ 15.01.2010. 01:55 ] @
kada se stampac ukljuci, nema apsolutno nikakvog zvuka ni pomeranja glave, samo lampice blinkaju naizmenicno zelena-narandzasta. nasao sam na netu da broj puta koliko se lampica upalila oznacava kod greske, znaci dva puta je greska ta i ta, tri puta ta i ta... kod mene se pali deset puta, a za taj broj ne pise nista, naravno... ne reaguje ni na kakvu kombinaciju tastera, nista... kertridzi su novi, originalni. ima neko neku ideju?


Canon Service Call Errors


Posted on September 18th, 2007 in All Instructions, Side by QuadCore ||
Service Call Errors (by LED Blinking in Orange and Green Alternately, or Lit in Orange)

LED alternate blinking
in orange and green

Error [Error code] .
2 times Carriage error [5100] .
3 times Paper feed error [6000] Make sure paper is in the tray and nothing is blocking it.
4 times Purge unit error [5C00].
5 times ASF (cam) sensor error [5700
6 times Internal temperature error [5400
7 times Waste ink absorber full [5B00] You have printed a ton of borderless pictures and the overspray has filled the sponge.
8 times Print head temperature rise error [5200] .
9 times EEPROM error [6800] .
11 times Carriage lift mechanism error [5110] .
12 times AP position error [6A00] .
13 times Paper feed position error [6B00] Sometimes it’s something simple like a hunk of paper stuck under the print head, another more radical trick is to turn the printer upside down and shake it. Be careful though you may spill ink or cause damage to the printer.
14 times Paper feed cam sensor error [6B10]0 .
15 times USB Host VBUS over current [9000] .
16 times Valve sensor error [6C00] .
17 times Motor driver error [6D00] .
20 times Other hardware error [6500] .
Continuous alternate blinking ROM error .
Lights in orange RAM error .

http://damnprinter.com/226/canon-service-call-errors.html

. . .
[ dendic @ 15.01.2010. 11:15 ] @

-------------sa neta:
had the same problem. To solve the problem, I swapped positions with the yellow and magenta, and the light on the magenta cartridge stayed bad. By this I knew my magenta cartridge was the problem. I then pried the bottom of chip outwards to give it a better contact and the flashing yellow light (15flashes) went away and the printer worked normally
Each cartridge has a electronic chip pre-porogrammed at the factory.
If it is a reputable store they will exchange for the right color as they can return the PM to Canon as defective,

Jesu li ti cisti ti kontakti na chipovima?
[ fangorn @ 15.01.2010. 12:46 ] @
to nije isti problem, covek kaze da mu narandzasta blinka 15 puta, nije kao kod mene naizmenicno narandzasta-zelena 10 puta. pored toga njemu se glava pomera i stane na sredinu kad otvori poklopac a kod mene se UOPSTE ne pomera ni malo, uvek stoji u lock polozaju skroz desno i kertridzi ne svetle, znaci apsolutno nikakvog zvuka ni pomeranja nema, samo blinkanje lampica naizmenicno 10 puta i tako u krug. samim tim ne mogu ni da izvadim kertridze da ih zamenim/ocistim, a i oni su stavljeni novi, originalni pre dve nedelje i odstampano je desetak strana. nesto drugo nije u redu.
[ fangorn @ 19.01.2010. 10:56 ] @
crkla glava, kada sam je ocistio jasno se vidi pozadi gde su kontakti i flat kabl kako je jedna linijica na kablu izgorela, znaci sledi mu kanta..
[ enaB @ 02.03.2010. 10:09 ] @
Kod mene je isto tako crkla na iP4200, ali je blinkalo 20 puta. Isto se vide nagoreli vodovi na providnom flat kablu na glavi. Taman sam bio odštampao onu test stranicu i vidim nema svetle plave i svetle crvene, posle pogledam a on blinka |: