[ vladabugarin @ 20.02.2010. 17:02 ] @
Kako rešiti problem, štampač pri svakom uključenju izbacuje ovu grešku Ink System Failure error 0xc18a0207.
Resetovao sam par puta i opet ništa. Šta dalje?

[Ovu poruku je menjao vladabugarin dana 20.02.2010. u 21:56 GMT+1]
[ dendic @ 20.02.2010. 20:30 ] @
HP photosmart 3110,ink system problem...

I reset by holding down OK, Cancel, Colour and Black buttons and pressing off button. Then turned machine on. It took a few minutes to reset. Voila.

Printed a test page - Perfect
THANK YOU THANK YOU THANK YOU.
[ vladabugarin @ 20.02.2010. 20:47 ] @
Citat:
dendic: HP photosmart 3110,ink system problem...

I reset by holding down OK, Cancel, Colour and Black buttons and pressing off button. Then turned machine on. It took a few minutes to reset. Voila.

Printed a test page - Perfect
THANK YOU THANK YOU THANK YOU.


Nema ovih tastera na ovom modelu.

[ Igor Gajic @ 20.02.2010. 20:59 ] @
Probaj, ne moze da skodi:

Resetting HP Photosmart C6180 & C7180 "system failure" errors:
(might work on other similar models as well)


1) press * and # at the same time

2) press 1, 2, 3 and “support R0632M” should display

3) press > and “information menu” should display

4) press > and “configuration menu” should display

5) press OK and “hardware failure status” should display

6) press OK “failure status: clear”. Press OK to clear

7) press CANCEL

8) press CANCEL

9) press CANCEL

10) turn printer off, unplug power cord for 2 minutes, plug cord back in then turn printer back on.


http://www.inkbank.com.au/webcontent21.htm
[ vladabugarin @ 21.02.2010. 17:10 ] @
Sve je to OK, ali na štampaču nema tih tastera. Pogledaj sliku štampača.

[ Igor Gajic @ 21.02.2010. 20:47 ] @
http://www.fixya.com/support/t451942-help


Citat:

*** Fix your HP Photosmart D7360 (Reset Code/Master Reset) ***

1- Turn off power and unplug from power source.
2- Open right side of printer (looking at the front).
3- Disconnect,by pulling gently, both white flat ribbon cables off the main circuit board.
4- Plug in power source and turn printer on. Wait till you get a error message and push "Ok".
5- Unplug power source.
6- Reconnect the flat ribbon cables by aligning and carefully pushing into the conectors on the main circuit board.
7- Plug in power source and turn printer on (Printer preparing occurred).
8- voila, the nasty error message 0xc18a0001 "Ink System has Failed" is now gone.