To će morati neko ko ima fabriku diskova. Verovatno može da se nađe kako se to radi ali me ne zanima previše. Ako znaš kako su se pravile gramofonske ploče, ovo je tu negde. Koliko znam, ništa se ne reže i ne prži, od spremljene matrice se prave diskovi ... a možda su me i lagali. U svakom slučaju ništa od toga ne možemo da iskoristimo za kućne potrebe.
Evo ipak malo informacija koje sam na brzinu našao:
Citat:
Manufacture
Main article: CD manufacturing
Replicated CDs are mass-produced initially using a hydraulic press. Small granules of raw polycarbonate plastic are fed into the press while under heat. A screw forces the liquefied plastic into the mold cavity. The mold closes with a metal stamper in contact with the disc surface. The plastic is allowed to cool and harden. Once opened, the disc substrate is removed from the mold by a robotic arm, and a 15 mm diameter center hole (called a stacking ring) is removed. The cycle time, the time it takes to "stamp" one CD, is usually 2 to 3 seconds.
This method produces the clear plastic blank part of the disc. After a metallic reflecting layer (usually aluminum, but sometimes gold or other metals) is applied to the clear blank substrate, the disc goes under a UV light for curing and it is ready to go to press. To prepare to press a CD, a glass master is made, using a high-powered laser on a device similar to a CD writer. The glass master is a positive image of the desired CD surface (with the desired microscopic pits and lands). After testing, it is used to make a die by pressing it against a metal disc.
The die is a negative image of the glass master: several are typically made, depending on the number of pressing mills that are to be making the CD. The die then goes into a press and the physical image is imposed onto the blank CD, leaving a final positive image on the disc. A small amount of lacquer is then applied as a ring around the center of the disc, and fast spinning spreads it evenly over the surface. Edge protection lacquer is also applied before the disc is finished. The disc can then be printed and packed.
Manufactured CDs that are sold in stores are sealed via a process called "polywrapping" or shrink wrapping.