[ shpiki @ 14.12.2011. 09:16 ] @
Kod mene je jos na testiranju, ako jos neko hoce da proba - evo link.
What's new

Pozdrav.
[ Darko_zed @ 14.12.2011. 15:17 ] @
inace moj omiljeni programcic ,hvala.
-Pazi ako ima virusa ili bagova ubicu te ako se razocaram.
Pozdrav
[ ZAS011 @ 14.12.2011. 15:52 ] @
Jedino ga jos "boli glava"
[ bogdan.kecman @ 17.12.2011. 04:41 ] @
obrati paznju da 6.0 ima par ozbiljnih problema

1. ne moze da snimi 5.x format, samo 6.0 (fala k. bar ume da procita stari), dakle kad snimis semu otvorenu u sestici to je to, nema vise vracanja na 5
2. 6.0 ima gadan bug da copper zone mogu da "nestanu" kada exportujes cam izlaz

Citat:

WARNING: Most unfortunately, after the whole release process for version 6.0.0 had been finished, it turned out that there is a bug in the polygon handling of the CAM Processor.
If a board contains signal polygons that have their “Orphans” parameter set to “off”, and the CAM Processor is used to generate production data with the “pos. Coord” (positive coordinates) option turned on, and if this actually leads to an offset in the CAM data, it can happen that parts of the signal polygons are not drawn, even though they are not orphans, and vice versa.
This may lead to missing electrical connections or copper in places where this is not intended.
As an immediate workaround you can turn the “pos. Coord” option off.
We are working on a solution for this and will release a fixed version as soon as possible.
Sorry for the inconvenience.
[ ZAS011 @ 21.12.2011. 10:33 ] @
Novu zverku vise ne boli glava, popila je aspirin, a bag i dalje postoji mada, kazu, retko se desava.
[ bogdan.kecman @ 22.12.2011. 02:58 ] @
ne znam ni cemu sluze one pozitivne koordinate tako da se bug lako sprecava :D