Ako i malo znaš engleski skontat ćeš


Test the drivers first before run the software. Follow these steps:
1. Find one 616
2. Connect the phone to the cable - it must be switched on
3. Install the drivers
4. When the installation for all drivers finished:
4.1. Remove the battery
4.2. Connect the phone to USB cable
4.3. The led will shine first then the display as well.
4.4. Few seconds later the display must be blue and to have this text:
A:
C:
blue(color not text)
blue(color not text)
blue(color not text)
.
.
.
blue(color not text)

616v: the test mode display on the e616v appears on the
small outer display and not the inside screen.

5. If you can't see this you must start again with drivers installation.
Without these drivers the program can't work.
If you have not this result(4.4.) you can't use the program

Kakvu grešku dobijaš?

Šta koristiš za dekodiranje tog NECa?

Jesi li modifikovao kabal?



meni posle ovoga radi

Hvala, problem je u modifikaciji kabla.

Dakle za one koji trebaju raditi NEC_a,program NEC FREE radi 18 v a E616v 22v neradi.

finally ,tested e616v v18,works.
schematic is good pin 4+5 short to +5v ,, 8,9,10 -short.
How do it?Well, like this:
1.conect phone without battery
2.install driver
3.open soft and conect phone without battery
4.select com port manual
5.phone is conected and readed
6.disconect phone
7.enter your phone imei manual
8.soft generate codes
9.enter nck,spck
10 phone is unlocked

here you can see all the pictures shown below